Specification

Device Specifications

• neoVI 3G Architecture over 10x performance over previous devices
• 3 DSPs and 1 RISC processor for 125 MIPS of processing
• Power Consumption (typical) : 150mA @ 14.4 VDC
• Sleep Power Consumption (typical) : 12mA @ 12.0 VDC
• Power Supply: 6-27 Volt Power Operation (Physical layers non functional under 6 volt)
• Dual user notification LED (red and green)
• Temperature Range: -40C to +85C
• Vehicle Connectors : 25 Pin male D-SUB and 9 Pin Male D-SUB
• Warranty: One Year Limited Warranty
• Firmware: Field upgradeable design (flash firmware)
• Microsoft Certified USB drivers
• Isolated USB
• Stand-Alone Mode Including Scripting, Receive Messages, Transmit Messages, Expressions, IO, and Transport Layers
• microSD card slot support for up to 32 Gigabytes of storage (A 2 GB cards is included with the device.) The removable card is formatted using FAT32 for direct usage in a PC. *ICS supplied SD cards required; Other SD cards not supported.
• Battery backed real time clock (RTC).

Network Specifications

Networks - General

• 64 Bit time stamping to accuracy of 10 microseconds on CAN networks and never overflows. 0.5 microsecond accuracy timestamp available if using one network only.
• Simultaneous operations on both CAN networks.
• Transmit message double-buffering on both CAN network allows back to back message transmission.

2x CAN Channels

• 1 Dedicated ISO11898 Dual Wire CAN Physical Layer (TJA1040)
• 1 User selectable from  ISO11898 Dual Wire CAN Physical Layer (TJA1040), ISO11519 Low Speed Fault Tolerant CAN Physical Layer (TJA1054A), or Single Wire CAN Physical Layer GMW3089 / SAE J2411 (MC33897)
• CAN 2.0B Active
• Up to 1 M-Bit Software Selectable Baud Rate (auto baud capable)
• Capable of generating and detecting error frames (With firmware update)
• Graphical Bit Time / Baud Rate Calculator
• Listen only mode support
• High Speed Mode, Test Tool Resistor, and High Voltage Wakeup support

Return to overview...